I needed something more than a 2 cavity (I have a nice Ly 356420) because of the number of 9mm Luger that I am going to load. So, after reading what several had reported about this mould, I went ahead and ordered a 6-banger from Midway early Monday morning. I arrived yesterday. When I got home I cranked up the pot, cleaned and lubed the mould and then went to eat supper (Okie soul food - beans, fried taters and corn bread). After eating and cleaning up, I went to the shop and commenced casting. The new Lee moulds are an improvement over years past. Anyway, a short 60ish minutes later I had a nice pile of bullets. They are typical Lee, slightly out of round, but all cavities are close together with measurements on each running .358-.360ish. After a pass thru a lube-sizer I am confident they will be just fine for 9mm fodder.