MP 360-640

[Ben]

This is one of my favorite 38 / 357 cast bullets.
I use it a lot in my two lever action 38 / 357 lever action rifles.
A fine mould.
I also have the penta point and deep HP pins.

Ben

 

[Spindrift]

Nice bullets!
I have a 6-cav solid mould, that I use for plinkers in my .35 Whelen. I like it

 

[CWLONGSHOT]

Yup its been a good one for me as well!

 

[Brad]

I have that. It in the 168 (?) gr version- dual crimp grooves.
An amazing bullet

 

[462]

Man, it would certainly be nice if my Rossi/EMF 92 and Uberti/Cimarron 1866 liked semi-wadcutter bullets, because I certainly like that bullet. That they don't, I'll keep them fed with Lee's 358-158 RF.

 

[Petrol & Powder]

Man, it would certainly be nice if my Rossi/EMF 92 and Uberti/Cimarron 1866 liked semi-wadcutter bullets, because I certainly like that bullet. That they don't, I'll keep them fed with Lee's 358-158 RF.

The MP 360-640 that Ben is showcasing is a round nose flat point. It lacks the 3rd driving band outside the case like a true SWC.
You might find that bullet profile feeds better than a true SWC.

If your gun feeds the Lee 358-158 RF it would likely feed that MP profile.

 

[Ben]

If your gun feeds the Lee 358-158 RF it would likely feed that MP profile.

YES ! !

 

[Ben]

My rifles, A Rossi 92 , 357 Mag., and My Marlin CBC 38 Spec. will feed the MP design like water running through screen wire.

Ben

 

[fiver]

i bet it feeds too.
that bullet profile is super similar to the RCBS bullet.

 

[462]

SWCs feed fine, it's a matter of accuracy.

 

[Tomme boy]

I really like this bullet. I have the 4 cav. I have to seat it a little deeper in the 357mag to get it to rotate. I ave to seat it right at the top edge of the crimp grove. It shoots very well in this 6.5" gun.

I have shot a few out of a 9mm too. They don't leave much room for powder in the 9mm

 

[Ben]

I tried an MP " 640 " Penta Point from my mould in a 9mm Luger round.

Jammed.

Ben

 

[Brad]

That is the only bullet my Marlin 357 shoots well at all.