CWLONGSHOT
Well-Known Member
Diggin in my bag a tricks...
LOOKIE LOOKIE WHAT I FOUND!! (NB is no box.)
CW
LOOKIE LOOKIE WHAT I FOUND!! (NB is no box.)
CW
OMG the prices!!!
- Thread starter CWLONGSHOT
- Start date
CWLONGSHOT
Well-Known Member
CWLONGSHOT
Well-Known Member
Yes I would!
But only in the bottom.
Maybe a taperd pin w/Wood handle, so it still holds some lead & I dont burn my fingers?!
Cadillac Jeff
Well-Known Member
OH MAN!!!!!
Nice find!
Nice find!
Mowgli Terry
Active Member
This not relevant to the 357's. I had Eric turn the gas check step out and hollow point a 429215. Worked very well. I was shooting these bullets in 44 Special loads.
I got hooked on the 358477. I just finished some loads using the 358156 bullets in 357 Magnum. I did PC a run of 358495 WC's. That worked out very well-as advertised.
There's several HP molds for that bullet here. There is an old factory 358429 HP mold that was packed up for Eric to replace the missing pin. . At moment several appliances in the house broke down. All shooting stuff went on the back burner. This bullet casting stuff is highly addictive.
I got hooked on the 358477. I just finished some loads using the 358156 bullets in 357 Magnum. I did PC a run of 358495 WC's. That worked out very well-as advertised.
There's several HP molds for that bullet here. There is an old factory 358429 HP mold that was packed up for Eric to replace the missing pin. . At moment several appliances in the house broke down. All shooting stuff went on the back burner. This bullet casting stuff is highly addictive.
Last edited: