1 Tame and 2 Monster's

[boatswainsmate]

Hello All,
I made these 3 bullets today. NEI 451 255, LBT 452-310-OWC-GC and the LBT 452-350-WLN-GC Thanks for looking. Boats

 

[Glaciers]

Are these from your new Moulds?
They look nice.

 

[CZ93X62]

Those do look nice. Megafauna season is closer than you think.

 

[boatswainsmate]

Are these from your new Moulds?
They look nice.

Yes. I just got them a big group from auction.

 

[Glaciers]

What are you using the 310 & 350 in? Long Colt? Or something else.

 

[boatswainsmate]

The 310 will go in my 45 colt. I think the 350 has to long a nose for my 45 colt or 454. I do have a 460 Snubbie I could use it in but I'm not sure I want that much punishment.

 

[RBHarter]

Time to get a 460 rifle or a 45 Raptor .

 

[CWLONGSHOT]

Very nice batch of molds!!

I had a very nice 310g 452 WFN mold from LBT once. Either misplaced or loaned out and cannot find. I still have some bullets. Wish I had now to experiment with PC it was a good design for PC. I picked up a LEE 300 as a quick replacement (better size wfn) but the bullet is fat and requires deep seating in most guns.
I borrowed a RD 300 mild and cast up about 500 and that one is better but still not perfect after PC. My Rossi 45 LOVES BOTH!! My Marlins do OK with Lee and great with RD my Ruger shoots both but requires deep seating. I dont usually feed my SAA, such heavies they wont take either bullet with out a deep seat. That included a Colt New Frontier.

 

[Hawk]

I've attached LBTs order form where they dicuss the different nose designs.
All of his designs were to have a heavy bullet, but with as much of it out of the case as possible to allow for more powder.

 

[Bliksem]

The lower 2 look like they would work well in a 450 Bushmaster bolt rifle, that's what I would use them in if the molds were mine.