38-158-SWC

Creeker

Well-Known Member
I have 7 of these moulds by Magma. I have used one of them in my Master Caster. I can't remember how close the weight was to 158 grains but they did cast either .360 or .361. They are bevel based. Each one comes complete with keys & sprue plates by Magma. 50.00 each shippied.

20200821_180317.jpg

20200821_180344.jpg

20200821_180503.jpg
 
Last edited:

Creeker

Well-Known Member
No Sir they aren't drilled for handle screws. If the holes were drilled they would work with RCBS handles but the end of the handle must be shorten somewhat to clear the sprue plate bolt which is exposed in the handle groove.
 

CWLONGSHOT

Well-Known Member
Its a pretty easy alteration IF THE BLOCKS where drilled. I have a few molds with the Magma star spure cutters. No stop, but its not difficult to align.
I keep a Lyman and a LEE with one side altered to fit. Ten minutes on a grinder and a bit with a file.

Nice molds!

CW
 

Creeker

Well-Known Member
CW is right, the handles aren't hard to fit but the blocks must be drilled like Lyman or RCBS moulds are in order to use pins or screws to attach the handles to the blocks.
 
I have 7 of these moulds by Magma. I have used one of them in my Master Caster. I can't remember how close the weight was to 158 grains but they did cast either .360 or .361. They are bevel based. Each one comes complete with keys & sprue plates by Magma. 50.00 each shippied.

20200821_180317.jpg

20200821_180344.jpg

20200821_180503.jpg
Do you still have them?
 
Great will pass these on to my friend that needs some. Will get back to you.
you can text me at 530-570-7685 if you want to, is quicker at times .He is interest, would like to know what the other molds are.
 
Last edited: