Dented cases?

Ian

Notorious member
Always push the shoulder back first and then neck down. A .358 Win form/trim die has gotten a lot of use at my house over the years, as has a shortened .308 die.
 

MikeN

Member
Wow! Thanks for the good advise. I set my .308 sizer for the just a tiny bit short of the shoulder for the 7x57 and run them through and then through the 7x57 form/trim die and cut them off. I will then trim them and run them through the 7x57 FL sizer. I only did 20, but got 100% good cases. Forming cases is something I'm new at, I've only necked down 30/30 to 7/30 Waters, but that doesn't require moving the shoulder back. Thanks again!
 

mattw

Active Member
Throw them in a padded envelope... I am sure that someone here with an 06 will fire form that out for you...