FS: Mold & Dies

Ben

Moderator
Staff member
Lyman #358212 mold- 38 cal-146gGC- 2 cavity. $30

When I look for a photo of this mould, the picture that is shown is of a plain base bullet ?

gO5ByFw.jpg


You say yours is a GC mould ? ?
 
Last edited:

porthos

Active Member
check your PM i tried again. concerns the redding 308 bushing die. i don't know why it didn't go thru?
 

Ben

Moderator
Staff member
9. Lyman #358212 mold- 38 cal-146gPB- 2 cavity. $30

I'll buy your mould.

PM Sent to you.
Ben
 

porthos

Active Member
the only PM that i got stated that there were no bushings with the die. thats OK. i'll still take the redding 308 bushing die. let me know how you want paid
 

porthos

Active Member
also if we can connect; i'll send you my personal e-mail. that will make things easy. or you send me your e-mail
 

Ben

Moderator
Staff member
I can't figure out why the PM system isn't working with the 2 of you ? ? ?

Ben
 

Ben

Moderator
Staff member
Bob and I have PM'd also without any problems of any kind ????????????
 

Rick

Moderator
Staff member
I've been scratching my head over this also. If it persists might be something for Kevin to look at. It's over my head why it would be working fine for everyone except a couple of people unless they have something in their set-up set wrong.
 

Ian

Notorious member
Under "settings" there is a section called "privacy". Under "privacy there is a section to "allow users to....." and one box is receive private messages. The preference can be set to "members only", "people you follow" or something else I can't remember since a minute ago when I looked. Make sure that setting is "members only", which means members and staff. Any other selection will pare down the list considerably and not allow private conversations to be started between the whole membership.
 

GWarden

Active Member
Ian
I went there and I had everything checked as you mentioned. Finally got messages through and the world is back to normal. Thanks.
bob
 
  • Like
Reactions: Ian