Gas checks stuck in case necks

[mattw]

I use a pin drill and make a small hole in the middle, most will pull out with just slight pressure on the bit when removing it from the hole.

 

[JWFilips]

Hate to say this ....since I do not know how hot the loads are But I have just reseated the bullet down to about on top of them and fired them when the load was low

 

[Hawk]

I didn't think the loads were that hot. I was just trying to fire form the brass. But I was getting flat primers and severely scratched base of cases, so I stopped and pulled all the bullets. This was not a load I usually use but one that I had extrapolated and thought was safe for fireforming.
Better to be safe than sorry.

 

[JWFilips]

You could just flip them sideways by pressing one end in the case and pull them out with a hooked wire....I have done that also

 

[Freischütz]

Small diameter gas checks coming off and falling into the case really vexes me. Sometime I can catch the loose gas check in the case neck by using an inertia puller. Then I can reach it with long nosed pliers.