CZ93X62
Official forum enigma
I only have two wadcutter moulds, both 2-banger Lymans--#313492 and #358432. These were among the first two moulds I bought when I started in 1981.
I don't have many round-nose moulds, either--and those I do have were meant for balky autopistols. I was an Elmer Keith acolyte, and I was all about the semi-wadcutter for revolvers. Levergun addictions brought round flatnose bullets into the mix as the years wore on.
But wadcutters languished. And still do, though a lot of my current revolver shooting is done now in the 750-900 FPS realm. Maybe if/when mould supplies normalize again a wadcutter mould might find its way into the collection.
I don't have many round-nose moulds, either--and those I do have were meant for balky autopistols. I was an Elmer Keith acolyte, and I was all about the semi-wadcutter for revolvers. Levergun addictions brought round flatnose bullets into the mix as the years wore on.
But wadcutters languished. And still do, though a lot of my current revolver shooting is done now in the 750-900 FPS realm. Maybe if/when mould supplies normalize again a wadcutter mould might find its way into the collection.