Headed down another Rabbit hole. Shotgun slugs!

CWLONGSHOT

Well-Known Member
Revisited these new fragmenting slugs as I picked up the #6x5/8 screws needed.

Well nope. The hole cast thru the slugs fits nicely but the "bore" where the head of the screw sits is too small and wont allow the screw to sit deep enough.

I sized and set the drill press to leave a 1/8" thickness but bore the hole so the screw enters far enough. Seems to be OK but still not ideal. I gonna stop and see if a 1" #6 is made. If not I will grab some as long as I can get.
Its not aweful drilling the slugs. Might be better from a continuity stand point.

CW
 

fiver

Well-Known Member
I know they make a 3/4" #-6 but I don't remember if I bought pan head or wood screw type when I got them at the ACE.