Kevin Stenberg
Well-Known Member
I have an MP 358-640 HP Brass mold. And the pins are placed too far into the mold so they do not make contact with the apposing contact recess.
The tools i have on hand to adjust the male pin. I have c-clamps. and a bench vice. And that is it. I just remembered i have a drill press i could use like an arbor press.
The base of all 4 pins are flat, and recessed about 3/16ths below the outer face of the mold.
The tools i have on hand to adjust the male pin. I have c-clamps. and a bench vice. And that is it. I just remembered i have a drill press i could use like an arbor press.
The base of all 4 pins are flat, and recessed about 3/16ths below the outer face of the mold.
Last edited: