Bliksem
Active Member
Part of my available tool set that supplements my hobby is a number of 3D printers. Here are some pics of a some snap-in followers that ride on top of the standard follower. The magazine pictured is an AR Stoner 10 round .223" unit and the cartridge is a 450 Bushmaster with a Lee C453-300-RF powder coated with clear. This combination allows 3 rounds of 450 BM or 458 Socom. Note there is a small half-moon cut out in the front of the magazine that was created using a sanding drum in a Dremel as rounds would hang up when fed slowly. Hope this helps somebody.