quicksylver
Well-Known Member
I thought I would give you an explanation as to why I posted the question about bevel base bullets. I recently ordered a mold from Tom, as usual it was a work of art for sure. now I'm not blaming Tom,as I miss under stood how his site works. It was a dual cavity ,dual design mold, one cavity was to be 36-155S the second was 36-168C, the bodies were to be .359 +/_.001, and they were.3585as cast., NOW comes the mix up. Under special notes I requested losing the bevel base. on the 155 S. THAT DIDN'T HAPPEN. Apparently that would have required me to summit a NEW design. Tom prides himself on his communication, I wished that instead of his going ahead and cutting the mold he had dropped me a note stating that a new design would have to be summited. So lesson learned , Tom will make you what you want but not by using the special notes blocks. My bad.
