358156 hp
At large, whereabouts unknown.
I've heard of these moulds before, but this was the first I've seen in person. I guess it's not that difficult to screw up the simplest jobs:
One thing I noticed was that the alignment pins are also reversed, at least as compared to most of my similar vintage molds. My oldest mold, a 360270 HP is a true reversed mold, with the handle screw holes running through the top of the mold downwards. The alignment pins are in the more conventional locations, only my '50s vintage (EBay taught me to hate that word!) 357446 have the pins in the same orientation.
There probably isn't a factory spec for pin location, out of all my moulds, only these two are like this, with the pins in the same block as the sprue plate.
If this sort of thing is driving me nuts, I probably need to do something else for awhile!
One thing I noticed was that the alignment pins are also reversed, at least as compared to most of my similar vintage molds. My oldest mold, a 360270 HP is a true reversed mold, with the handle screw holes running through the top of the mold downwards. The alignment pins are in the more conventional locations, only my '50s vintage (EBay taught me to hate that word!) 357446 have the pins in the same orientation.
There probably isn't a factory spec for pin location, out of all my moulds, only these two are like this, with the pins in the same block as the sprue plate.
If this sort of thing is driving me nuts, I probably need to do something else for awhile!