johnnyjr
Well-Known Member
I've been fooling around with this mold some using linotype with gas checks. Only tried at 50 yards with IMR 4227 powder. To say the least,I was pretty impressed. I used only 3 loads of each. My first was 3 in close to one hole. The others opened to like 1/4 inch to 1/2 inch.
Now these were with full length sized brass annealed. I am going to try the same loads with neck sized just to see if there is much difference in them. Sorry no pictures. Courious if a 50 50 alloy will be as good..
Now these were with full length sized brass annealed. I am going to try the same loads with neck sized just to see if there is much difference in them. Sorry no pictures. Courious if a 50 50 alloy will be as good..