Elric
Well-Known Member
http://ps-2.kev009.com/ohlandl/Cast_Bullet/TC_Schuetzen/Contender_Schuetzen.html
I have a bit of time on my hands... Tried to figure out a decent mounting block for the SB16 shaft end support, in the end, I found a chunk of flat stock steel, 1 3/4 high, 2 wide, and 3 1/4 wide. Tried to figure out how to mount the support on the block, while allowing access to the bolts that fasten it to the T-Nuts...
Unfortunately, the SB16 base is 3 1/4 wide, which covers the top of the T-Nut bolts, so a straight drill, top down, is out. The spacing of the SB16 mounting screws is 2 1/2, which just don't line up....
If the flat stock is a bit low, a good pair of scissors and a pop can will fix that. I need to get close to 1.758, so this is not nuck-lear rokkit science...
I have a bit of time on my hands... Tried to figure out a decent mounting block for the SB16 shaft end support, in the end, I found a chunk of flat stock steel, 1 3/4 high, 2 wide, and 3 1/4 wide. Tried to figure out how to mount the support on the block, while allowing access to the bolts that fasten it to the T-Nuts...
Unfortunately, the SB16 base is 3 1/4 wide, which covers the top of the T-Nut bolts, so a straight drill, top down, is out. The spacing of the SB16 mounting screws is 2 1/2, which just don't line up....
If the flat stock is a bit low, a good pair of scissors and a pop can will fix that. I need to get close to 1.758, so this is not nuck-lear rokkit science...