yodogsandman
Well-Known Member
The BLL coated loads were much better. After the first 3 shots that were in a line 2 1/2" wide, the rest (7) went into about 1 1/2". I say about because I lost one off the bottom of the target. All of the shots were 4" low on the target. Will try this again! The bore was super clean after, too! So, after the first few "fouling" shots, the BLL coated loads settled down into a nice group. The load was 21.0gr of surplus SR4759 under a NOE 311-165 RD (FN) cast of 50/50 COWW's +2% Sn/ pure lead ignited by WLR primers.
The 666-1 with alox added loads shot about a 5" group. I shot at the top of the paper plate target to center them better this time. Same load with just a lube change.
The 666-1 with alox added loads shot about a 5" group. I shot at the top of the paper plate target to center them better this time. Same load with just a lube change.