CWLONGSHOT
Well-Known Member
Could you put me in touch with them? Please?
I have a CVA Scout 2 in 44 mag. It came with a factory one piece scope mount and rings pre installed. The mounting system is hell for stout BUT: I found that the mounting screws on the one piece scope mount that came with the gun were too long. They would tighten and the mount would feel tight but would start skating around after 5 or 6 shots. I took a couple of threads off each screw and all has held since then. Check out the mount, I'm pretty sure mine isn't the only one with that problem. It was a bugger to track down, kept shooting into two groups.I’m starting to suspect the scope being a problem but I’ll wait until I shoot these loads before I change it.
I can try. He was closing up shop October 30th, retiring I guess, but I think he’s still going to do gun shows. I’ll give him a call and see what he says.Could you put me in touch with them? Please?
Thank you very much!!I can try. He was closing up shop October 30th, retiring I guess, but I think he’s still going to do gun shows. I’ll give him a call and see what he says.
I called today and I was wrong, it’s a 35 Whelen and still on the rack and they are still open! For the current market, he has a good selection of powder and a not bad selection of bullets. Only 209 primers available. Barbersfirearms.comThank you very much!!
I am licensed in PA.
But all done thru FFL of coarse.
CW
Yup they do.... Just not in 35 Rem any longer.CVA still makes the single shot rifles.
you get a long barrel or short barrel with screw off thread protector.
i was looking at them yesterday.
Same here OF!! Same here!!No CVA Scout experience. But have a 336 in 35 Rem and BLR in 358 Win - oh YEAH - AND a Contender bbl in 357 Herrett! I LOVE the 35s! If it is in 35 Rem, I am two thumbs up. Pretty much the same with anything 35. Two 'calibers' I am HUGE fans of are anything 6.5 and anything 35! Oh yeah, and anything 45/458 too!
I did think about that but the twist on 38/357 mag is slower then 35 Rem. From many manufacturers. I dont see a 357 offered from CVA but could from Henry.So what you do is snag one in 38/357 and rent/borrow/buy reamers for 35 Rem and 30-30 , buy a 30-30 extractor/ejector and ream for 35 Rem and set the head headspace with the 30-30 reamer . Run 30-30 case in the 35 Rem die and trim .