Purely hypothetical..... not that I'm opposed to trying it,just don't have any dies that are "disposable".
Take a std chambering.... we'll say a 308....
If you,"nicely" lathe turned off .050" from the bttm of a sizing die,and then ran a case up in it,would that .050" "show up" as an increase in neck length?
NOT suggesting a dang thing,fully realizing a die blank and a custom reamer would be the proper way to make,whatever dimensions.... and,the need/importance of chamber vs sizing die specs.
Just curious what y'all thought would happen "to the case" (not how it would fit an existing chamber OR,how much sense it makes)....where would the brass flow to?
Take a std chambering.... we'll say a 308....
If you,"nicely" lathe turned off .050" from the bttm of a sizing die,and then ran a case up in it,would that .050" "show up" as an increase in neck length?
NOT suggesting a dang thing,fully realizing a die blank and a custom reamer would be the proper way to make,whatever dimensions.... and,the need/importance of chamber vs sizing die specs.
Just curious what y'all thought would happen "to the case" (not how it would fit an existing chamber OR,how much sense it makes)....where would the brass flow to?