Latest activity

I could be wrong, but those look more like a Manurhin MR88 than an MR73. The Manurhin MR73 is considered by many to be the finest .357...

I have a Spanish Destroyer carbine in 9mm Largo. The bullet diameter is the same size as any other 9mm, I believe. It shoots like a...

I put the Apex sear in the M&P 40 just now. Before the trigger showed 6 lbs 9 oz to 7 lbs 0.5 oz. After it was running about 4 lb 8 oz...

Yes, these groups were with hornady copper checks, and lube. I also think I am getting close to a node, exciting! Thank you for your...

You're shooting those with just lube and a gas check, correct? Might try going up to 38 grains in half-grain increments (or smaller)...

Tried this bullet with some slower powder today, same Howa .308, same alloy and lube. IMR 4064 33- 35 grs, and N- 140, 35 grs (had 5...

Tried this bullet with some slower powder today, same Howa .308, same alloy and lube. IMR 4064 33- 35 grs, and N- 140, 35 grs (had 5...

60 gr of 3031 under a 500 gr cast ......:oops: That sounds fairly hot at first glance. Of course, I shoot 57 gr of W748 as my standard...

The 577 Super Snider is a single shot largely because nobody was strong enough to carry the rifle when loaded with 5 rounds.

I do recommend the Lyman Cast Bullet book, but IME, they seem to shoot their bullets at notably smaller diameters than I use. Other...

Nice rifles. I visited RSA years ago. passed a few battlefield sites, but did not manage to get to Rourke's Drift. I have a Nepalese...

Dad's 1917 and my Smith have no clip chambers but the Colts is fat throated .

That is good info, Ian. I was wondering about the comments that some just swirl and 'generate static', but I have no idea what is what...

I believe the pin polishing and heat to be the most helpful for me. Just takes a few seconds each pin when chucked in a cordless drill...

I have at least 10 of them, and I can get all of them to work. They need to be hot, and the some of the pins have needed a good...