waco
Springfield, Oregon
I'm using a new NOE 312290 four cavity AL mold. I'm getting slight variance in the nose size. Anywhere from some bullets measure as small as .299" and up to .3015"+ The majority are between .300" and .301"
My alloy for this run was 50/50 ww pure plus 2% foundry type air cooled.
They are all a very consistent weight of right around 220gr.
I cast up about 350 of these and I've only checked about 10 or so using a mic.
Is it enough to even worry about or should I just load them up and let the target tell me?
Seems that some of the bullets are .299" across the seam and .302" 90 degrees from that.
Your thoughts?
Waco
My alloy for this run was 50/50 ww pure plus 2% foundry type air cooled.
They are all a very consistent weight of right around 220gr.
I cast up about 350 of these and I've only checked about 10 or so using a mic.
Is it enough to even worry about or should I just load them up and let the target tell me?
Seems that some of the bullets are .299" across the seam and .302" 90 degrees from that.
Your thoughts?
Waco
Last edited: