I finally feel like I have a good load for the 44 mag.
Using the MP 44/444 HP mould and an alloy of 5 pounds monotype to 50 pounds range scrap and heat treating for a full hour at 400 F then quenching. Sized to .4315, loaded in Starline cases with a Fed LP primer and 21.5 gr of H110.
The 8 in the group are just barely over 2 inches measured center to center. The low shot O don't know what exactly happened. The far left shot should have never been taken. The gun was moving and I let it go anyway. At the shot I knew it wasn't good.
Much time was spent focusing on grip. Placement of hands on grip along with where pressure was put with hands. It makes all the difference in the world.
Using the MP 44/444 HP mould and an alloy of 5 pounds monotype to 50 pounds range scrap and heat treating for a full hour at 400 F then quenching. Sized to .4315, loaded in Starline cases with a Fed LP primer and 21.5 gr of H110.
The 8 in the group are just barely over 2 inches measured center to center. The low shot O don't know what exactly happened. The far left shot should have never been taken. The gun was moving and I let it go anyway. At the shot I knew it wasn't good.
Much time was spent focusing on grip. Placement of hands on grip along with where pressure was put with hands. It makes all the difference in the world.