Tomme boy
Well-Known Member
I need to make a gas check expander. I had to lap a mold and now the gas check shank is just a hair big to get the checks on.
Anyo e have any guesses as to the diameter and the tapor I should go? I have not measured the base yet but how hard they are to get on the base is bigger than before. A firm push with your thumb is all it used to take.
It is for 350 legend with bullets to a final size of 0.356". Conventional lubes and checked with a 0.358" die in my rcbs lubes. Then final sized in my Lee app push through to 0.356"
I want to try conventional lube bullets in the ruger bolt gun now that I don't have to worry about the gas system of an ar15.
Anyo e have any guesses as to the diameter and the tapor I should go? I have not measured the base yet but how hard they are to get on the base is bigger than before. A firm push with your thumb is all it used to take.
It is for 350 legend with bullets to a final size of 0.356". Conventional lubes and checked with a 0.358" die in my rcbs lubes. Then final sized in my Lee app push through to 0.356"
I want to try conventional lube bullets in the ruger bolt gun now that I don't have to worry about the gas system of an ar15.