rodmkr
Temecula California
OK I am sure it has been posted somewhere but have not been able to find it.
Here is the problem.
I have recently replaced the barrel on my 8MM Mauser.
New barrel is new unused military barrel so has no gas cutting of throat.
Have a BRP siloute mold that the nose section is a bore rider.
Does not chamber.
I know there is a way to do nose sizing but have never done it
( and basically don't understand it) so is there a post or u-toob that
not only explains it but shows some kind of drawings on what you need.
Would like to build whatever I need.
Any help appreciated
Jim
Here is the problem.
I have recently replaced the barrel on my 8MM Mauser.
New barrel is new unused military barrel so has no gas cutting of throat.
Have a BRP siloute mold that the nose section is a bore rider.
Does not chamber.
I know there is a way to do nose sizing but have never done it
( and basically don't understand it) so is there a post or u-toob that
not only explains it but shows some kind of drawings on what you need.
Would like to build whatever I need.
Any help appreciated
Jim