Mowgli Terry
Active Member
The Plastic Plug is a real Dillon part. It is the white plastic peg the locates the spacer for the small bar in the power measure. I managed to shear one of those things. The spacer came loose. Surprise, Surprise. What happened them was the remaining Accurate #2 dumped onto the floor. I cleaned up the mess. The damaged powder appeared intact save the broken plug.
There was some resistance on the down stroke on the press. The end of the plug was still in the spacer. The excitement started immediately.
I called Dillon. Rep was terse and did not respond to my question. Two of the plugs are on the way. He would not take my order for #2 pins but would send two along. This response made me wonder what's going on there. Also, I'm still trying to figure out had that plug was broken. A help is greatly appreciated.
There was some resistance on the down stroke on the press. The end of the plug was still in the spacer. The excitement started immediately.
I called Dillon. Rep was terse and did not respond to my question. Two of the plugs are on the way. He would not take my order for #2 pins but would send two along. This response made me wonder what's going on there. Also, I'm still trying to figure out had that plug was broken. A help is greatly appreciated.
Last edited: