JWFilips
Well-Known Member
Digging back In my stash of 30 caliber bullets I did a few years ago...I decided to PC some already oversized 311291 plain base bullets that I used to pan lube and shoot that size....however Since now I pc'ed them unsized.... When I started to bring them down to .311 I started to see a nice "Alloy and PC" skirt form on the base! If it were only an alloy skirt.... I have in the past pulled them over some fine emery paper! But If I do that to these I take off the pc coating around the base also. Now I know I'm only going to be shooting these in "low node" loads as usually for me so it may not pose a problem....Figure I would throw it out to the forum for any ideas
Thanks
Jim
Thanks
Jim