Think I ordered mine straight from Eagan. Might be gone now or retired from making dies. Check on cast boolits site of Cast Bullets Association site. Somebody was making them.
Basically it's a sizing die without lube holes with a brass center punch. Entrance runs about .304" or so and exit's about .295" or so. Mine has a 1.5 degree taper. No holes. Works in a Lyman or RCBS sizer. I'm using a couple of #450s.
You lube bullet and apply gas check. Then, bullet goes in nose first. Comes with a flat top punch. You adjust bottom stop screw to attain nose diameter./beagle
Basically it's a sizing die without lube holes with a brass center punch. Entrance runs about .304" or so and exit's about .295" or so. Mine has a 1.5 degree taper. No holes. Works in a Lyman or RCBS sizer. I'm using a couple of #450s.
You lube bullet and apply gas check. Then, bullet goes in nose first. Comes with a flat top punch. You adjust bottom stop screw to attain nose diameter./beagle