fiver
Well-Known Member
antimony dendrites will do the job too.
if you keep the loads in the 3-4gr area like you have been I doubt a crimp will even be necessary.
I have a taper crimp die I use for all kinds of target loads.
you could make one easy enough with that reamer you have, and some polish time on the lathe.
if you keep the loads in the 3-4gr area like you have been I doubt a crimp will even be necessary.
I have a taper crimp die I use for all kinds of target loads.
you could make one easy enough with that reamer you have, and some polish time on the lathe.